Fast-Drying
Excellent Adhesion

SURFACE PREPARATION:

Metal Surface: Ensure that metal surfaces are clean and dry, free from rust, oil, grease, dirt, dust, and other foreign matters.

Wood Surface: Rough wood should be sanded and dusted off. Putty hairline cracks in wood and other minor surface defects.

APPLICATION SYSTEM

New Metal and Wood Surfaces
1st Coat: Lacquer Primer

Make sure that the substrate is free from oil, grease, or moisture before applying PARALUX LACQUER PRIMER in medium wet coats to the desired build. Allow flash-off between coats. It may be wet or dry sanded in 40-60 minutes. Use 500-grit sandpaper.

2nd Coat: Lacquer Putty
3rd Coat: Lacquer Primer
Topcoat: Automotive Lacquer Topcoat

Repainting Work:
1. Remove the defective paint.
2. Strip off the badly-conditioned old lacquer finish.
3. Prepare to clean and dry before finishing as indicated for "New Metal and Wood."
4. If the old lacquer finish is in good condition, sand and dust off the surface.
5. Apply the required finish coats of Automotive Lacquer.

Keep the container dry and tightly closed in a cool and well-ventilated place.

Opened containers must be resealed carefully and kept upright to prevent leakage.

Always keep in containers with the same material as the original one.

Observe label precautions.

Contain and collect spillage with a non-combustible absorbent material like sand.

For more information about the safety precautions of this product, please request for the safety data sheet.